You are currently viewing CA CA based pricing. To view US US based pricing, please click carbideanddiamondtooling.com
Cart

For an additional 250,000 Products visit our New Sister Site

 

American Davis Style Keyseating Broach 1/16 to 1 Inch and 4.0mm to 25mm Metric Sizes ID 752-

Part Number:752-
American Davis Style Keyseating Broach 1/16 to 1 Inch and 4.0mm to 25mm Metric Sizes ID 752-
American Davis Style Keyseating Broach 1/16 to 1 Inch and 4.0mm to 25mm Metric Sizes ID 752-

Price

Your Price: $424.68
in stock

See Description Below for Specifications

Description

American Davis Style Keyseating Broach 1/16 to 1 Inch and 4.0mm to 25mm Metric Sizes ID 752-
KEYSEATING BROACHES
HSS keyseating pull broaches are manufactured similar to the Davis AF Series cutters and are interchangeable
Cutter bars have 10° rake face, 5° backoff and 2° side-relief on all teeth.
Broaches may be used on Davis model 4, 5, and 15 machines.
The side relief eliminates drag in multiple-pass broaching.
Tooth-relief, using BorazonTM wheels, improves surface finish and extends tool life.
Precision grinding of the rake face insures consistent performance and free cutting action after several sharpenings.
American Davis Style Keyseating Broach 1/16 to 1 Inch and 4.0mm to 25mm Metric Sizes ID 752-

Feature 6

Broaching with Production Keyway Broaches

Broaching with Production Style Keyway Broaches requires no Shims or Bushings. The back and shoulders of the Broach are ground to fit the diameter of the bore, supporting and guiding itself while cutting the keyway in one pass. All individual stock Broaches have recommended Minimum and Maximum Length of Cut guidelines which should be followed. Workpieces may be stacked to establish the Minimum Length of Cut, or to improve the efficiency of the operation as long as Maximum Length of Cut is not exceeded. Proper nesting and clamping of stacked parts is vital when this approach is taken. The workpiece must be solidly fixed or nested perfectly square with the baseplate and ram face. Make sure all square and parallel surfaces on the face of the ram and baseplate remain true. It is essential to maintain a rigid set-up at all times and caution should be taken when stacking parts to maintain the integrity of the set-up. Never attempt to exceed the Broach's specified Maximum Length of Cut. Do not use a dull Broach, this may result in poor finish or damage to part and increases the danger of breakage. At the beginning of a cut, be sure the Broach is centered under the ram. Proper alignment is important. After the Broach starts to cut, back off pressure on the ram allowing the Broach to center itself, providing for better alignment. If the Broach moves out of alignment after starting cut, back off the pressure on the ram and align the broach itself. Repeat this procedure during successive cuts. This will assure a perfectly straight broached hole..

Select desired Broach and insert pilot into bore of part.
    Lubricate.
    Apply pressure to the Broach - back off pressure on the ram allowing the Broach to center itself, providing for better alignment. If the Broach moves out of alignment after starting cut, back off the pressure on the ram and align the broach itself - reapply pressure to push Broach through the work.
    Clean Broach using a stiff brush to remove chips from cutting section.
    Repeat steps 2 thru 4 for subsequent parts.


Related Items

 
 

Recently Viewed Items

Hello Guest | Log in!
Information
Browse by Category
Browse by Price